How to Clean a Cat Water Fountain (Pump Included)
A simple step-by-step routine for cleaning a cat water fountain, including the pump, plus how often to change the filter for popular brands.
- By
- Sajime
- Published
- Reading time
- 5 min
DisclosureWe may earn a commission when you buy through links on this site, at no extra cost to you. As an Amazon Associate we earn from qualifying purchases.

To clean a cat water fountain, unplug it, empty it, take it apart, and wash the parts in warm water with a mild, unscented dish soap. Keep soap off the filter. Give the pump extra attention, since hair and slime collect inside it. Use a small brush, rinse everything really well so no soap is left behind, put in a fresh filter if it’s due, then refill and plug it back in. Your fountain’s manual has the final word on which parts can go in the dishwasher and how often to change the filter.
What you need
- Mild, unscented dish soap
- A soft sponge or cloth
- A small bottle brush or pipe cleaner for the pump and tubes (many brands sell cleaning kits)
- A replacement filter, if it’s time
- A towel to lay the parts on
Skip bleach and strong cleaners unless your manual says they’re OK. Cats have sensitive noses, and leftover smells can put them off drinking.
Step-by-step: a full clean
- Unplug the fountain before you touch any water. On battery models, switch it off or take out the pump unit as your manual describes.
- Empty the water and remove the top, the filter and any covers.
- Take out the pump. On most fountains it sits inside the reservoir under a small cover. Catit’s Easy to Clean Flower Fountain is an exception: Catit says the pump motor sits in the base, so the reservoir lifts off with no pump inside. You still take out the small impeller to clean it, and Catit says to wipe the base with a dry or lightly damp cloth and never submerge it.
- Open the pump. Most pumps have a small cover you can pop off to reach the impeller, the little spinning part. Gently pull it out and wipe off any hair or slime.
- Scrub everything except the filter. Wash the bowl, lid and spout parts with warm soapy water. Use the brush in corners, tubes and the pump housing. Don’t put electrical parts like a plug-in base or power cord under water.
- Rinse well. Rinse every part until no soap smell is left.
- Swap the filter if it’s due (see the table below), or rinse it under plain running water if your brand allows that. Catit, for example, says to rinse its filter pads but never wash them with soap.
- Put it back together, fill it above the minimum line and plug it in. Check that the water flows evenly.
Can it go in the dishwasher?
It depends on the model, and the pump almost never can. A few examples from the makers:
- PetSafe Drinkwell 360 Stainless Steel: PetSafe says the fountain is top-rack dishwasher safe, but the pump should be washed by hand.
- PETLIBRO Dockstream 2: PETLIBRO says its stainless steel water tray is dishwasher safe.
- Catit Easy to Clean Flower Fountain: Catit’s cleaning guide describes hand washing with dish soap and doesn’t mention the dishwasher.
- Other plastic fountains like the classic Catit Flower: check your manual before putting any part in the dishwasher.
How often to change the filter
Filters are where most of the day-to-day “gunk” ends up. Here’s what the makers say for the fountains in our best cat water fountains guide:
| Fountain | Filter change (per the maker) |
|---|---|
| Catit Flower Fountain | Every 30 days, or sooner if it looks saturated |
| Catit Easy to Clean Flower Fountain | Rinse the filter pad when you clean, replace it when it’s very dirty |
| PetSafe Drinkwell 360 Stainless | Carbon filter every 2-4 weeks, foam filter every 1-2 months |
| PETKIT EverSweet Solo 2 | About 30 days in normal mode, 60 days in smart mode |
Filter guidance is from each brand’s product pages, filter pages, cleaning guides and quick start guides, checked in November 2026. Homes with several pets, or with hard water, may need changes more often.
How often to clean the whole fountain
Follow the schedule in your manual. If yours doesn’t give one, a quick rinse and top-up between full cleans, plus a full clean every time you change the filter, is an easy routine to remember. Clean it sooner if you see a pink or slimy film, if the water looks cloudy, or if the pump gets louder.
Hard water and white crust
If you see white, chalky buildup, that’s usually minerals from tap water. Some owners use filtered water to slow it down. If your manual allows it, a soak in diluted white vinegar can help loosen the crust. Catit, for example, suggests equal parts water and white vinegar in the reservoir of its Easy to Clean Flower Fountain, left for about 15 minutes if needed. Rinse very well afterward so no vinegar smell is left.
Signs your fountain needs attention
- It’s louder than usual. Low water or hair in the pump are common causes. Top it up and clean the impeller.
- The flow is weak or uneven. A clogged filter or pump is the usual suspect.
- Slime or a pink film. Time for a full clean.
- Your cat stops using it. A dirty or smelly fountain can put cats off. If your cat suddenly drinks a lot more or a lot less than usual, call your vet.
Make cleaning easier next time
If cleaning is the chore you dread, the design makes a big difference. Look for fewer parts, a stainless steel bowl, or a pump that sits outside the water. Our best cat water fountains guide compares these points for five popular models. Tired of scooping too? See our best self-cleaning litter boxes.
Catit Easy to Clean Flower Fountain
A Flower Fountain with a pumpless reservoir. Catit says all the electronics sit in the base, so the 2 L reservoir lifts off for cleaning, and the pump stops when you remove it. Includes an LED nightlight with a low-water indicator.
- Capacity
- 2 L / 70 fl oz (per Catit)
- Design
- Pumpless reservoir, pump motor in the base drives a magnetic impeller (per Catit)
- Auto stop
- Pump shuts off when the reservoir is removed and restarts when it is replaced (per Catit)